Hello Makers!
I am back again with a new Robotics model with the steering mechanism. This model is called Rob-Oto (Robotronics Auto) and can be made by Robotronics LITE or Robotronics FULL kit.
Watch Video
Steps for making a Robo – Oto
Step : 1
Connect A long U with a short U by adding flexible strip at one side and make its pair and connect both with a Short Rectangle plate.
Step : 2
Now connect 2 motors at both Short U side in center hole no 2 & attach wheel on both motors and fix with axle lock.
Step : 3
Take a flexible strip bent from both the side as shown in figure and add a motor in middle, add 4 fillers & a small round gear and fix with an axle shaft.
Step : 4
Joint two 4 inches axle shaft with help of coupler and fix it in lower hole no 8.
Step : 5
Now add 2 L angle with help of 3 three hole connector and add a square plate on both L- angle & add 1, 2 or 3 wheels with a 4 inch axle shaft middle hole of last row of square plates & fix with the axle locks.
Step : 6
Now take a 3 inch axle shaft and fix it in the 2nd 3 hole connector and lock it from the inner side.
Step : 7
Now add a flexible strip on hole no 4 of long U and fix it with that wheel set and insert a big round gear and lock with the axle lock.
Step : 8
Now install a FULL / LITE brain and connect wires. And your Rob-Oto is ready!
Your Robot is Ready!
Facing any Challenge in the making? Send us an email at support@avishkaar.cc or drop a chat message here and well get back to you soon as soon as possible.
Made the Robot? Show off your innovation to the world! Post it on our Facebook Page .
Stay tuned for more such tutorials! 🙂
Akshay Kumar
Robotics Expert
Team Avishkaar